RTK SURVEY MODE - CONNECT ALL COMPONENTS OF S82
For base:
1 tripod is accurately centered and leveled over the point (the point could be known point or unknown point)
2 position the base mainframe on the tripod.
3connect the radio (transmitter-receiver) to base mainframe with all-purpose cable (the cable has two functions: provide power and transfer data)
4 Connect emitting-antenna to the radio (transmitter-receiver)
5 Power on base mainframe and radio (15w or 25w, adjustable)
The base will begin to transmit differential signal after a few minutes (the time needed mainly depend on the status of the satellite)
Note:
You can find four indicator lights and a key-press on the panel. From left to right:
indicates current status, the light remains light in the rtk mode and blinks in static mode (for example, the light blinks every 5 seconds if you set the interval to be 5 seconds).
Dl indicates status of data link, the light will blink twice quickly every five seconds in rtk base mode. For the rover, the light blinks every second. In static mode, the light will light all long time for base and rover.
Indicates status of satellite and the connection of bluetooth, the light has two colour, the left one indicates the satellite’s status, it will blink every 30 seconds (for example if the light blinks six times it rapresent the receiver fixed six satellites) The right one will light all long time is the handhold computer is connected to rover with bluetooth.
Indicates status of the power. When power supply is enough the light remains light all long time, otherwise, it will blink clue to replace battery. When power is external power, the right light will light (green).
Has two functions: power on/off and switch survey mode (for example, remains pressing the key, whe you hear beep 3 times then you loosen the key quickly, it will power off the receiver, when you hear beep 4 times then loosen the key, the receiver will be power off, continue to power one, it will be switch to rtk mode; when you hear beep 5 times then loosen the key, the receiver will be power off, continue to power on, it will be switch to static mode; when you hear beep 6 times then loose the key, the receiver will be power off, continue to power on, it will initialize the receiver.
For rover:
The manipulation is simple compared to the base. Attach the radio antenna to rover and power on, the rover receiver will begin to receiver differential signal and get into fixes status in a few minutes. The panel is the same as base.
Has two functions: power on/off and switch survey mode
