Prepare to connect the receiver to computer. Connect the receiver to serial port (COM1 or COM2 or USB) of computer with communication cable. Make sure power supply is sufficient, then power on.

Wait about 10 seconds (it will take about 10 seconds for the receiver to inter the main interface. Note data transfer must be in main interface of receiver) then connect.

Open data transfer software. Set target path to save the raw data in data transfer software. For example, we create directory. We select directory “common files” then click input directory name.

Communication parameter setting.

Click meny communication, select communication port then select COM1 or COM2.

Click “communication” start connect or click toolbar.If communications parameter is correct, the raw data saved in the receiver will display on the lower-right dialog box. Otherwise, please re-check communication parameter, re-do step 1.

Select raw data file on the lower-right dialog box, then click toolbar, it will come out the following dialog box. Select raw data file, click start, the selected file will be transferred. We can see current status on the lower of the dialog. (If you want to change the point name, antenna height, session, etc, you can select the file then click modify). When data is downloaded, click break to break the connection between the receiver and the computer.
GPS 9200 are availbale on http://www.totalstationshop.com/

The leader of surveying items

This entry was posted on Tuesday, April 17th, 2007 at 8:57 pm and is filed under Uncategorized. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.